35C50 Airless® Paint pump
- Designed for long-lasting industrial use
- Fast color changes with minimum solvent consumption
- Simple design to minimize maintenance time and operation
The 35C50 Airless® paint pump will deliver excellent performance and outstanding benefits because of our proven pumping technology. With a powerful air motor, the 35C50 can feed up to 2 SFlow™ Airless® spray guns. It can handle material viscosities from 20 cps up to 5000 cps with very low air consumption. It comes with an optimized volume fluid section for fast color changes with minimal material loss.
The 35C50 Airless® paint pump packages are ready to spray systems, available in wall-mount versions with cart as an option. Packages are available with the SFlow™ Airless® manual spray gun equipped with a 12.13 (515) reversible tip and 7.5 m (25ft) fluid hoses. A large variety of accessories are recommended to meet various customer needs.
This pump is also available as Airmix® system with Xcite™ spray gun.
Additional Airmix® version with the Xcite™ spray gun are also available.
|Designation||Value||Unit: metric (US)|
|Maximum Fluid Pressure||210 (3000)||bar (psi)|
|Recommended Fluid Output||750||cc/mn (cfm)|
|Maximum Fluid Output||1000||cc/mn (cfm)|
|Maximum Air Pressure||6 (87)||bar (psi)|
|Air Consumption||15||m³/h (cfm)|
|Maximum Temperature||60 (140)||°C (°F)|
|Fluid Output at 30 cycles/mn||1.5 (0.4)||l/min (gal/mn)|
|Fluid Volume per Cycle||50||cc|
|Free Flow Rate||3 (0.79)||l/mn (gal/mn)|
|Fluid Output at 15 cycles / mn||0.75||l/mn (gal/mn)|
|Seal Packings||MB-A cartridge|
|Fluid Outlet||M 1/2 JIC|
|Fluid Inlet||M 26x125|
|Wetted Shares: Stainless Steel||♦|
This technology represents a new generation of sealing designed to extend the life of a pump piston.
2 ball pumping technology is highly utilized in fluid sections with one ball / seat for suction & the other ball / seat for feeding.
Epoxy primer/sealer is a non-porous finish that is typically recommended as the first base coat over bare steel.
Designed to hide profile & surface imperfections, multi-component polyurethane primers & sealers improve adhesion of top coats to the substrate due to the addition of a hardener.
Designed to hide profile & surface imperfections, water-based primers & sealers are environmentally friendly.
Designed to hide profile & surface imperfections, polyurethane primers & sealers promote adhesion of top coats to the substrate.
Polyurethane Top Coat is a two- or three-pack isocyanate-cured polyurethane that gives a durable, high gloss finish. Isocyanates included in the hardener are moisture-sensitive & need a specific process for insulating the circuit.
Two-part epoxy coatings were developed for heavy duty service on metal substrates & use less energy than heat-cured.
Water-based polyurethane is popular because of its low odor & low toxicity. It goes on clear without adding a faint color like oil-based versions do & it dries much faster.
Subcontractors of the surface treatment and the coating process for the general industry
Protection, bonding, finishing, dispensing & sealing for interior & exterior joinery